Arcadian Networks Inc. V390I Benutzerhandbuch
4 Configuring the V390i
36
V290iA User Guide
Configuring V390i Components
The V390i contains two configurable components:
V384+A UHF Modem Board – All V384+A configuration is performed using the
NMS (refer to the NMS User Guide).
NMS (refer to the NMS User Guide).
Cisco Router – detailed in the following section.
Configuring the Cisco Router
This section describes the Cisco default configuration, and an example of SCADA traffic
configuration. It also provides a QoS configuration example and WiFi configuration
instructions.
configuration. It also provides a QoS configuration example and WiFi configuration
instructions.
V390i Cisco 3200 Default Configuration
The V390i Cisco 3200 component default configuration enables the following
operations:
operations:
Local Telnet connectivity to the UHF modem via the FESMIC LAN interfaces for
management and monitoring purpose.
management and monitoring purpose.
Local Telnet connectivity to the WMIC card via the FESMIC LAN interfaces for
management purpose.
management purpose.
WiFi client’s connectivity.
Serial ports connectivity by Telnet tunneling. In this configuration, data can be
received or transmitted using Telnet to the router IP address with the relevant TCP
port.
received or transmitted using Telnet to the router IP address with the relevant TCP
port.
The default configuration disables all the dynamic routing protocols and the Cisco
discovery protocol.
discovery protocol.
Cisco 3200 Default Configuration CLI Commands
The following displays the V390i Cisco 3200 default values’ running configuration.
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
no service config
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
service timestamps log datetime msec
no service password-encryption
no service config
!
hostname Router
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model