drakesystem co. ltd DSCAR001 Benutzerhandbuch

Seite von 8
the system will arm automatically after 30 seconds. When the car is armed,
it acts like above procedures.
Note  1: Passive arming is selectable feature that can be turned ON or OFF
  by your alarm dealer / installer. Please check the installation guide.
2-1-3.  Special functions when entering into arming : When the door is opened
and the “LOCK” button is pressed, the car alerts 4 chirps & 4 light
flashing.
When the shock sensor is triggering and the “LOCK” button is pressed, the car alerts
3 chirps & 3 light flashing. The car does not alert this status even though it is in arm
mode, but , if the door is closed and opened again or if the shock sensor is muted
and triggered again, the car sends alarm signal.
2-2. DISARMING
2-2-1. Pressing the button “UNLOCK” shortly disarms the car.
        When the car is disarmed, it unlocks the door with two audible chirps and
visual light flashing. The remote controller shows green LED flashing and
sounds short beeps two times. If you press the “UNLOCK” button under
       “NO CHIRP MODE”, the car acts the same way above, but without chirp.
2-2-2.  The car memorizes the status of intrusion ( door open )in the arm mode
and alerts it when the car is disarmed. The car alerts 4 times light flashing and 4
times chirps. The remote controller shows 4 times of green LED and
long beeps. The car alerts 3 chirps and 3 light flashing for the triggering
of shock sensor during arm mode.
2-3. CAR FIND
When the button “AUX” is pressed shortly, the remote car shows audible beep and
visual lighting. The remote controller shows flashing of green LED and sounds
short beep four times.
2-4. 
PANIC (FOR YOUR PERSONAL SAFETY )
When the button “LOCK” or “UNLOCK” is pressed more than 2 seconds,
     the car will start alarming and flashing for 45 seconds. The panic can be
removed by pressing any button and it is helpful for your personal safety.
2-5. TRUNK 
OPEN
Pressing the button “ASTERISK” for more than 2 seconds can open
     the trunk of the car. At that time, the remote controller flashes green LED 5 times
     and sounds short beep 5 times.
2-6. VALET 
MODE
Valet mode is used to prevent from alarm system arming or triggering.
    The alarm should be put into valet mode when the vehicle is being serviced.
    Press the button ”AUX” more than 2 seconds during the car key is in the
    position of “ACC” in the key box, then VALET mode is activated.
At the VALET mode, the LED on the base communication module turns ON continuously