Wilson Electronics LLC 273201 Benutzerhandbuch
1
2
Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7am to 6 pm MST.
Warning: In a
wireless installation,
do not plug the Signal
Booster directly into
the cell phone and/
or data card using
an antenna adapter .
It may damage the
Signal Booster, cell
phone and/or data
card
.
!
!
!
Quick Installation Overview
Installing the Outside Antenna
To receive the best cell signal, select a location in the center of the vehicle’s roof 12 inches
To receive the best cell signal, select a location in the center of the vehicle’s roof 12 inches
away from any other antennas or windows . If the vehicle has a sunroof, it is important to
separate the Inside and Outside Antennas by at least five feet . This prevents the Signal
Booster from overloading or oscillating . As shown above . Follow the specific antenna
installation instructions included with the Outside Antenna .
Magnet - Mount
Antenna Shown
Part #301103
Carefully
Pull Down
Door Seal
Run Cable
Under Seal
Tuck Cable
Under Seal
Separation of the Inside and Outside Antennas is
very important . The metal roof of the vehicle acts as a
barrier and helps shield the two antennas from each
other, preventing oscillation (feedback) .
The Outside Antenna must be installed vertically .
The Outside Antenna must be installed vertically .
Signal performance will be degraded if the antenna is
not vertical .
The antenna cable may run through the door to the
The antenna cable may run through the door to the
Signal Booster .
For a more professional looking installation, run the
For a more professional looking installation, run the
antenna cable under the door seal . The antenna cable
is small enough to easily tuck under the door seal or
plastic molding . Carefully pull down the door seal . Run
the cable through the seal and push the seal back into
place . This prevents constant wear and tear on the
cable as the door opens and closes .
Warning: Do not plug
in the DC power supply
until the Outside and
Inside Antenna cables
are attached to the
Signal Booster .
Warning: Do not use any type of glass-mount
antenna with this Signal Booster . The Outside
and Inside Antennas must be shielded from each
other to prevent oscillation (feedback) .
Installation Diagram
Outside
Antenna
Inside
Antenna
Distance between antennas
through a sunroof must be 5
feet or more .
DC Power
Supply
Signal
Booster
Cell Phone
PDA
Notebook