Wilson Electronics LLC 273201 Benutzerhandbuch

Contact Wilson Electronics’s Technical Support Team with any questions at 866-294-1660

Or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7am to 6 pm MST.

Place the Low-Profile Antenna on the

side of the driver’s seat for maximum

performance .
Install the Low-Profile Antenna at least eight

inches, but not more than 12 inches, from

where the cellular device will be used .
Install the Low-Profile Antenna at the same

angle as the cell phone when held in use, or

place next to the laptop’s cellular data card .

This will maximize the signal strength .
For a more professional looking installation,

the Low-Profile Antenna may be slid under

the seat cover or upholstery, high on the

driver’s seat .

Warning: Do not install the low-profile

antenna within four inches of metal .

(Metal found inside the vehicle’s seat will

not affect the antenna’s performance .)

Signal Booster

Low-profile

Antenna

Installing the Low-Profile Antenna

Installing a Wilson Electronics Signal Booster

Warning: The Inside Antenna must be

installed with a separation of at least eight

inches from all persons and must not

be located in conjunction with any other

antenna or Signal Booster .

Warning: Do not plug in the DC power

supply until the Outside and Inside

Antenna cables are attached to the Signal

Booster .

Run the cable from the Outside Antenna and

attach it to the connector labeled “Outside

Antenna” on the Signal Booster .
Attach the Low-Profile Antenna cable to the

connector labeled “Inside Antenna” on the

Signal Booster .

Select a location to install the Signal Booster that is away from excessive heat, direct

sunlight, moisture and that has proper ventilation .

NOTE: The aluminum casing of a Wilson Signal Booster will adjust very quickly to the

ambient temperature of its environment. For example, in the summer, when the inside

of a car can reach 140 degrees Fahrenheit, the Signal Booster temperature may be 150

degrees or higher. The casing will be hot to the touch, similar to a metal door handle or a

steering wheel. Such high temperatures will not damage the Signal Booster, nor do they

pose a fire risk to the vehicle. As recommended in these instructions, install the Signal

Booster in a location with adequate ventilation, such as under the seat or under the

dashboard. Keep the area free of items that could block air flow to the Signal Booster.