Wilson Electronics LLC 273201 Benutzerhandbuch

About Wilson Electronics
Wilson Electronics, Inc . has been a leader in the wireless communications industry for over 

40 years . The company designs and manufactures Signal Boosters, antennas and related 

components that significantly improve cell phone signal reception and transmission in a 

wide variety of applications, both mobile, M2M and in-building .
With extensive experience in antenna and Signal Booster research and design, the 

company’s engineering team uses a state-of-the-art testing laboratory, including an 

anechoic chamber and network analyzers, to fine-tune antenna designs and performance . 

For its Signal Boosters, Wilson Electronics uses a double electrically shielded RF enclosure 

and cell tower simulators for compliance testing .
Wilson Electronics Signal Boosters feature patent-pending Smart Technology   ™ that 

enables them to automatically adjust their power based on cell tower requirements .  By 

detecting and preventing oscillation (feedback), signal overload and interference with other 

users, these Smart Technology   ™ Signal Boosters improve network cell phone areas 

without compromising carrier systems .
All products are engineered and assembled in the company’s 55,000-square-foot 

headquarters in St . George, Utah . Wilson Electronics has product dealers in all 50 states 

as well as in countries around the world .

This device complies with Part 15 of FCC rules . The transaction is subject to two 

conditions: (1) This device may not cause harmful interference, and (2) this device 

must accept any interference received, including interference that may cause undesired 

operation. Changes or modifications not expressly approved by Wilson Electronics could 

void the authority to operate this equipment .

 

Warning:   In a wireless installation, do not plug the Signal Booster directly into the cell 

phone or cellular data card using an antenna adapter .  It will damage the 

Signal Booster, cell phone or cellular data card .

 

Warning:  Do not plug in the DC power supply until the Outside and Inside Antenna 

cables are attached to the Signal Booster .

 

Warning: 

RF Safety: The Inside Antenna must be installed with a separation of at least 

8 inches from all persons and must not be located in conjunction with any 

other antenna or Signal Booster .

 

Warning: 

RF Safety: All Inside Antennas used with this Signal Booster may not have 

gain (less cable loss) that exceeds 15 dBi and must be located at least 8 

inches from all people . Outside mobile antennas may not have gain (less 

cable loss) that exceeds 2 .3 dBi and must be located at least 8 inches from 

all people . Outside fixed antennas may not have gain that exceeds 15 dBi 

(less cable loss) and must be located least 28 inches from all people . All 

antennas shown on page one meet these requirements .

 

Warning:  Use only the power supply provided in this package . The power supply must 

be 6 V DC Output .