Wilson Electronics LLC 276215 Benutzerhandbuch
1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.
1 . Install In-Building Signal Booster (such as the AG Pro 75 sold separately) .
Use the installation guide for the model you purchased to install .
2 . Select a location to install the In-Line Signal Booster that is away from
excessive heat, direct sunlight, moisture and has proper ventilation . Do not
place the Signal Booster in an air-tight enclosure .
3 . The In-Line Signal Booster should be placed where it can make up for
installation gain loss due to cable, taps or splitters . Optimal location is near
or directly connected to the Inside Antenna .
4 . a) Connect a cable to the in-building Signal Booster at the connector
labeled “Inside Antenna .”
b) Run the cable to the In-Line Signal Booster, attach to the connector
labeled “Outside Antenna .”
c) From the In-Line Signal Booster connector marked “Inside Antenna” run
a cable to the Inside Antenna . For more information on running cable (see
diagram on pages 3 & 4) .
5 . Before powering up the In-Line Signal Booster, verify that all cables
are connected and check that all connections are tight .
Note: Be careful
when plugging the connectors in so as not to bend the center pins on
the connectors (see page 7) .
6 . The In-Line Signal Booster has been packaged with the gain control
knobs adjusted to the highest gain position . If one or both of the lights
are not green (see pages 9 & 10) .
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660 .
Warning:
Connecting the Signal Booster directly to a cell
phone with use of an adapter may damage the cell
phone and/or the Signal Booster .