Wilson Electronics LLC 276215 ユーザーズマニュアル

1 . Install In-Building Signal Booster (such as the AG Pro 75 sold separately) .    

  Use the installation guide for the model you purchased to install .

2 . Select a location to install the In-Line Signal Booster that is away from  

 

  excessive heat, direct sunlight, moisture and has proper ventilation . Do not    

  place the Signal Booster in an air-tight enclosure .

3 . The In-Line Signal Booster should be placed where it can make up for  

 

  installation gain loss due to cable, taps or splitters . Optimal location is near    

  or directly connected to the Inside Antenna . 

4 . a) Connect a cable to the in-building Signal Booster at the connector  

 

  labeled “Inside Antenna .”

b) Run the cable to the In-Line Signal Booster, attach to the connector 

labeled “Outside Antenna .”

c) From the In-Line Signal Booster connector marked “Inside Antenna” run 

a cable to the Inside Antenna . For more information on running cable (see 

diagram on pages 3 & 4) .

5 . Before powering up the In-Line Signal Booster, verify that all cables    

  are connected and check that all connections are tight . 

  the connectors (see page 7) .

6 . The In-Line Signal Booster has been packaged with the gain control  

 

  knobs adjusted to the highest gain position . If one or both of the lights    

  are not green (see pages 9 & 10) .

See Installation Diagram on page 3 . Contact Wilson Electronics Technical 

Support Team with any questions at 866-294-1660 .

Connecting the Signal Booster directly to a cell  

 

 

phone with use of an adapter may damage the cell  

 

phone and/or the Signal Booster .