Wilson Electronics LLC 2B4310SM Benutzerhandbuch

Make sure both the outside antenna 

and other cables are connected before 

powering up the amplifier.
For vehicle use, connect the power cable 

from the DC power supply to the amplifier 

input marked “Power” and insert the large 

end into DC power socket (the cigarette 

lighter outlet).
For home or office use, connect the 

cable from the aC/DC power supply (sold 

separately) to the amplifier input marked 

“Power” and insert the plug end into a 

standard wall outlet.

The amplifier may remain on all the time.  

However,  leaving the amplifier on in a 

vehicle when it is not running can discharge 

the battery in a day or two.
A good option is to power the amplifier 

through the ignition switch so the amplifier 

is turned on and off with the vehicle.

notE:  The aluminum casing of the SignalBooST™ amplifier will adjust very quickly to 

the ambient temperature of its environment. For example, in the summer, when the inside 

of a car can reach 140 degrees Fahrenheit, the amplifier temperature may be 150 degrees 

or higher. The casing will be hot to the touch, similar to a metal door handle or steering 

wheel. Such high temperatures will not damage the amplifier, nor do they pose a fire 

risk. As recommended in these instructions, when installing the amplifier in a vehicle, 

select a location with adequate ventilation, such as under the seat or dashboard.  

Keep the area free of items that could block air flow to the amplifier.

iMPoRTanT:  Do not power up the 

amplifier unless the antenna and other 

cables are attached to the amplifier.

Warning: Use only Wilson power 

supply units.  Use of a non-Wilson 

product may damage your equipment.

Carefully insert the power cable.

The universal connector must be placed 

directly on the cellular data card to work 

properly.  attach the universal connector to 

the cellular data card with the VElCRo

®

 

included in the package.  

iMPoRtant:  

The adhesive of the gray Velcro patch 

needs time to “cure.”  For best results, 

do not use the Velcro connection for a 

minimum of 24 hours after application.
The universal connector and extension 

cable included in the package are long 

enough to reach the amplifier location.  This 

allows for ease and convenience of use.

12 V DC power supply (included)

aC/DC power supply (not included)