Wilson Electronics LLC 460003 Benutzerhandbuch

Select a location to install the Signal Booster that is away from excessive 

heat, direct sunlight, moisture and that has proper ventilation .  Do 

not place the Signal Booster in an air-tight enclosure . Recommended 

installation locations for in-building Signal Boosters are near a power 

outlet and in a closet or on a shelf .
Note: It is important to have adequate air ventilation. Maintain at least 6    

Run the Outside Antenna cable to the Signal Booster and attach it to the 

connector labeled “Outside Antenna” on the Signal Booster .  Run the 

Inside Antenna cable to the Signal Booster and attach it to the connector 

labeled “Inside Antenna” on the Signal Booster . 

1 .  Never point the front of a directional Outside Antenna toward the Inside 

Antenna . Refer to Figure 2 on page 12 . 

2 .  Ensure that both the Outside Antenna cable and the Inside Antenna 

cable are connected to the Signal Booster

 and the connections are 

tight before powering up the Signal Booster . 

3 .  Plug the power supply into the Signal Booster input marked “POWER” 

(carefully, to avoid damaging the center pin) and then into a 

Protector Power Strip. 

4 .  If the Signal Booster does not have green light(s), please refer to 

pages 12 & 13 . 

5 .  If you know the frequency bands that are available in your coverage 

area (or going to be used), reduce the gain control on the frequency 

bands that are NOT in use to the lowest dB setting . This will reduce the 

power consumption of the Signal Booster . 

6 .  Using multiple Signal Boosters in one installation may cause 

interference to the cell tower (except for the Wilson Electronics In-Line 

Signal Booster #806715) . 

7 .  Contact Wilson Electronics Technical Support Team with any questions 

at 866-294-1660 or email tech@wilsonelectronics .com . Technical 

Support hours are Mon .- Fri . 7 am to 6 pm MST .