Wilson Electronics LLC 460005 Benutzerhandbuch
6
ENGLISH
Need help?
www.weboost.com
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm
Face inside
antenna
away from
the outside
antenna.
Inside
Antenna
4. Use the mounting hardware included
in the package to secure the Inside
Antenna to the selected location.
Powering Up The Signal Booster
1. Ensure the cables to both the Outside
Antenna and Inside Antenna are
securely connected before powering
up the Signal Booster.
2. Plug the power supply into the Signal
Booster input marked “POWER” and
then into a surge protector power strip
with a minimum 1000 Joule rating.
!
3. The lights on the Signal Booster
should remain green . If the
lights are red or orange, see the
“Troubleshooting” section on page 7.
4. If you know that only one frequency
band (800 MHz or 1900 MHz) is
available in your coverage area,
reduce the gain control on the
frequency band that is NOT in use to
the lowest setting. This will reduce
power consumption of the Signal
Booster.
For illustrations of these installation steps,
view the install video at weboost.com/us/
Connect3Gvideo.
Signal Booster Installation
1. Select a location for the Signal
Booster that is away from excessive
heat, direct sunlight, moisture and well
ventilated. The enclosure must NOT
be air tight. Also, be sure the location
is near a power source.
2. Connect the coax cables to the Signal
Booster from the Outside Antenna
and Inside Antenna at the designated
ports.
3. Do NOT connect the Signal Booster to
the power source until all cables are
connected.
Inside Antenna Installation
1. Select a location in the center of the
area where you want cellular signals
improved to mount the Inside Antenna.
If you have multiple rooms with poor
signal, you may need multiple Inside
Antennas. These can attach to the
Signal Boost by using a splitter (sold
separately). Contact weBoost for more
information.
2. Ensure a minimum of 20 feet vertical
or 50 horizontal feet separation from
the Outside Antenna.
Place the inside antenna
directly beneath the
placement of the Outside
Antenna location
At least 20 feet of vertical or
At least 20 feet of vertical or
50 horizontal separation
Outside Omni Antenna
Inside Panel Antenna
3. Inside Antennas can be mounted
above ceiling drywall, on a ceiling
inside a room, or on a wall inside a
room. Ensure the Inside Antenna
is facing AWAY from the Outside
Antenna to avoid oscillation
(feedback).