Wilson Electronics LLC 460005 ユーザーズマニュアル

ENGLISH

4.   Use the mounting hardware included 

in the package to secure the Inside 

Antenna to the selected location.

1.   Ensure the cables to both the Outside 

Antenna and Inside Antenna are 

securely connected before powering 

up the Signal Booster. 

2.   Plug the power supply into the Signal 

Booster input marked “POWER” and 

then into a surge protector power strip 

with a minimum 1000 Joule rating. 

 

3.   The lights on the Signal Booster 

should remain green . If the 

lights are red or orange, see the 

“Troubleshooting” section on page 7. 

4.   If you know that only one frequency 

band (800 MHz or 1900 MHz)  is 

available in your coverage area, 

reduce the gain control on the 

frequency band that is NOT in use to 

the lowest setting. This will reduce 

power consumption of the Signal 

Booster.  

For illustrations of these installation steps, 

view the install video at weboost.com/us/

Connect3Gvideo. 

1.   Select a location for the Signal 

Booster that is away from excessive 

heat, direct sunlight, moisture and well 

ventilated. The enclosure must NOT 

be air tight. Also, be sure the location 

is near a power source. 

2.   Connect the coax cables to the Signal 

Booster from the Outside Antenna 

and Inside Antenna at the designated 

ports. 

3.   Do NOT connect the Signal Booster to 

the power source until all cables are 

connected. 

1.   Select a location in the center of the 

area where you want cellular signals 

improved to mount the Inside Antenna. 

If you have multiple rooms with poor 

signal, you may need multiple Inside 

Antennas.  These can attach to the 

Signal Boost by using a splitter (sold 

separately). Contact weBoost for more 

information. 

2.   Ensure a minimum of 20 feet vertical 

or 50 horizontal feet separation from 

the Outside Antenna.

3.   Inside Antennas can be mounted 

above ceiling drywall, on a ceiling 

inside a room, or on a wall inside a 

room. Ensure the Inside Antenna 

is facing AWAY from the Outside 

Antenna to avoid oscillation 

(feedback).