Comba Telecom Ltd. RX-7W22 Benutzerhandbuch
INSTALLATION GUIDE FOR RX7W22
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 16
3.3.4 WALL MOUNTING
Drill four holes on the wall using the position of four holes on the mounting rack as a guide. Fix the
mounting rack to the wall using four masonry bolts (M10x110mm).
Install the Mounting Rack2 on the both side of the enclosure.
Hang up the equipment and secure the enclosure to the mounting rack.
Hang up the equipment and secure the enclosure to the mounting rack.
Figure 5: PS BDA Wall Mounting
3.3.5 DRIP-LOOP
Comba recommends that every horizontal cable entry to the equipment forms a 'U' before its entry to the
equipment. Water on the cable will drip down at the bottom of the loop and will not accumulate at the
equipment connectors.
equipment. Water on the cable will drip down at the bottom of the loop and will not accumulate at the
equipment connectors.
Mounting Rack
Masonry bolt
8-M10x110
8-M10x110
PS BDA
8-M4x12, Hex socket
with washer bolt