Xsilogy Inc. 0920 Benutzerhandbuch
Before You Begin
Installation
2-2
Preliminary Release X1
Portable or stationary water facilities for rinsing eyes and skin in
case of contact with acid electrolyte
Bicarbonate of soda, mixed with a ratio of 0.l kg to 1 liter (1 lb to
1 gal) of water to neutralize acid spillage
Note
The removal and/or neutralization of an acid spill may result
in the production of a hazardous waste. Be sure to comply
with appropriate governmental regulations.
in the production of a hazardous waste. Be sure to comply
with appropriate governmental regulations.
Class C fire extinguisher
Note
Some battery manufacturers do not recommend the use of
C0
C0
2
Class C fire extinguishers due to potential of thermal
shock on the battery cases. Check with the manufacturer’s
instructions before using.
instructions before using.
Adequately insulated tools
Important Safety Precautions
WARNING: Full voltage and current are always present at
the battery terminals. Batteries can produce dangerous
voltages, extremely high currents, and possible risk of
electric shock. Batteries may cause severe injury if the
terminals are shorted together or to ground (earth).
the battery terminals. Batteries can produce dangerous
voltages, extremely high currents, and possible risk of
electric shock. Batteries may cause severe injury if the
terminals are shorted together or to ground (earth).
Observe the following protective procedures during installation:
Wear protective clothing, eyewear, rubber gloves, and boots.
Batteries contain corrosive acids or caustic alkalis and toxic
materials and can rupture or leak.
materials and can rupture or leak.
Remove all jewelry, and remove all metal objects from your pockets.
Jewelry and objects could fall onto the batteries or inside the battery
cabinet.
cabinet.
Use only tools with insulated handles, so they will not short battery
terminals. Do not place tools or other items on top of the batteries or
anywhere they could fall onto the batteries or inside the battery
cabinet.
anywhere they could fall onto the batteries or inside the battery
cabinet.
Prohibit smoking and open flames.
Ensure that the load test leads are clean, in good condition, and
connected with a sufficient length of cable to prevent accidental
arcing in the vicinity of the battery.
arcing in the vicinity of the battery.
Ensure that all connections to load test equipment include short-
circuit protection.
Ensure that battery area ventilation is adequate.