Xsilogy Inc. 0920 Benutzerhandbuch

Installation 

Overview of Installation Steps 

Preliminary Release X1 

2-3 

  Ensure unobstructed egress from the battery area. 

  Neutralize static buildup just before working on a battery by 

contacting the nearest effectively grounded surface. 

Parts Substitution 

Do not use substitute parts or perform any unauthorized modification of 
equipment. This will void your warranty and may create a hazardous 
condition. 

Overview of Installation Steps 

Installing BattGuard involves the following steps: 

1.  Install the Telesensor hardware on each battery cell.  

(See next section.) 

2.  Install the End-of-String module and connect to a PC.  

(See “End-of-String Master Installation Procedure” on page 2-7.) 

3.  Install the BattGuard software. 

(See “Software Installation Instructions” on page 2-7.) 

4.  Set up the battery strings so BattGuard can monitor them.  

(See “Setting Up Battery Strings” on page 4-1.)  

Hardware Installation Instructions 

All safety precautions listed in this document should be followed during 
BattGuard installation. Work performed on batteries should be done only 
with proper and safe tools and with the protective equipment listed in 
“Tools and Additional Equipment” on page 2-1.