WebGate Inc. WB106X-WG1K Benutzerhandbuch

 

 

22 

Dial-out 1: It is for WebEye to make dial-up progress to connect to ISP for PPP connection. WebEye dials 

up to ISP according to  the event that is configured at administration page of  ‘Application Configuration’. 

After PPP connection is made, WebEye sends e-mail or file. The process is as follows.   

• 

WebEye dials up to ISP to connect on Internet. 

• 

ISP asks information for login such as ID, password, etc, and WebEye answers to corresponding 
questions. 

• 

ISP makes PPP connection to WebEye and assigns an IP (official dynamic/fixed IP) to WebEye. 

• 

WebEye access Internet and send e-mail or file to pre-defined person or FTP server.  

 

Dial-o u t   2: While WebEye makes PPP connection to send e-mail or file, administrator may open to 

common users to access WebEye through Internet. For this purpose administrator should set WebEye to 

register itself on WRS (WebEye Registration Server). For detailed information on  WRS service, please 

refer to ‘Dynamic IP Registration Service’ configuration page in this manual.   

• 

WebEye dials up to ISP to connect on Internet. 

• 

ISP asks information for login such as ID, password, etc, and WebEye answers to corresponding 

questions. 

• 

ISP makes PPP connection to WebEye and assigns an IP (official dynamic/fixed IP) to WebEye. 

• 

WebEye connects to WRS (WebEye Registration Server) and list itself on the list. (More detailed 

information on WRS, please refer to Dynamic IP Registration Service in this manual.) 

• 

Users access Internet homepage of  ‘WebEye Dynamic IP Registration Server’ (www.webeye.to) and 

find out the WebEye in the list. 

• 

Users access WebEye to monitor real-time image on Internet. 

 

Dial-in : It is for a user to make PPP connection to WebEye with his PC that connects on Internet through 

dial-up modem. Detailed process is as follows. With this connection, only one user can access WebEye at 

the same time. 

• 

A user dials up to the modem that is connected to WebEye. 

• 

WebEye makes PPP connection to the user’s PC and assign an IP (private IP) to the  PC. In this case, 

WebEye assigns an IP address that is in the same local network compared to its own IP address. 

• 

Users access WebEye homepage through web browser by entering WebEye’s IP address to monitor 

real-time image. 

 

Below items especially user ID, password, and phone number are used for WebEye to connect ISP based on 

standard PPP.   

ID/Password: It is to put proper user ID and password for connecting to ISP.   
 

Phone: It is to put telephone number of ISP. If a prefix needs in dialing (e.g. 9), you should mark tick on the 

menu and put the prefix the following square.   

 

Disconnect Time : WebEye maintains connection for some while there is action such as sending e-mail or 

files. And when the action is stopped, WebEye disconnects after sometime. This is to configure how long 

WebEye maintains the connection after any action doesn’t occur.   
 

Login Script: If your telephone line needs special login script to connect ISP, you should enable  ‘Script 

Enable’ menu and describe the login script. At the section, there are some commands to describe script.   

- End: To end the login process.