WebGate Inc. WB106X-WG1K Benutzerhandbuch

 

 

23 

- Wait for: To wait for a certain signal. 

- Wait for Prompt: To wait for prompt. 

- Send: To send after described script. 

- Send CR (Carriage Return): It has the same effect to press ‘Enter’ key in the script. 

- Send User ID: To send the ID that is described in ‘User ID’ square. 

- Send Password: To send the password that is described in ‘Password’ square. 

- Delay: To delay for a certain seconds that  is described the following square. 

 

This page is to register WebEye on 

dynamic IP registration server.   

 
If WebEye is installed on a network of 

dynamic IP address (floating IP 

address), administrator should register 

the WebEye  on  dynamic IP registration 

server to give common users simple 

connectivity. If not, no one can access 

the WebEye through Web browser. It is because that no one knows IP address which one can access the 

WebEye with.   

 

To solve the problem, WebGate runs a server making a list of WebEyes that have dynamic IP  addresses. On 

the server, WebEye registers its information such as name, location, and description, so that common users 

may detect a certain WebEye. Name, location and description are assigned at ‘System Configuration ’ page. If 

administrator does not change them, the WebEye will register default information on the list, and it will be 
very difficult to point out and access a certain WebEye. The list is on an Internet homepage of WebEye 

(

www.webeye.to

). 

 

Administrator may register one’s WebEye by enabling  ‘Auto IP Registration Function’. Registration process 

is that WebEye detects IP addresses from DHCP server and informs the detected IP addresses to dynamic IP 

registration server.   

 

This is to configure a server address for registration. The registration server to be used for Dynamic IP 

registration should be installed proper S/W, developed by WebGate Inc.   

 

Dynamic IP address es  are commonly used with xDSL, ISDN or Cable Modem lines.  In order to maintain 
continuous connectivity, user should reset the ‘Registration Interval’ at a shorter time interval than the default 

value.   

 

There are two registration systems. One is to register on a public list and the other is on a private list.   

 

Access token is a password and it is used when you register your own WebEye on a list ‘User’s WebEye’ out 

of all WebEyes on WRS(WebEye Registration Server).