CipherLab Co. Ltd. 1663 Benutzerhandbuch
15
Update
Quick Start
The example below shows how to set numeric parameters:
Steps Action
LED/Beeper Response when Successful
1)
Power on the scanner...
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off.
(high tone) and its LED indicator will
become solid red and go off.
2)
Enter the Configuration Mode…
The scanner will respond with six beeps
(high-low tone repeats three ti mes), and
its LED indicator will become flashing red.
(high-low tone repeats three ti mes), and
its LED indicator will become flashing red.
Read a Setup barcode...
For example,
The scanner will respond w ith two beeps
(low-high tone) if reading a normal setup
barcode.
(low-high tone) if reading a normal setup
barcode.
3)
The scanner will respond wi th one short
beep if r eading a special setup barcode
such as “Max. Length”, i
beep if r eading a special setup barcode
such as “Max. Length”, i
ndicating the
setup requires reading more barcodes.
Read the “Decimal Value” barcode(s).
Refer to Appendix IV “Decimal
System”
System”
The scanner will respond w ith two beeps
(low-high tone) when th e input values are
validated.
(low-high tone) when th e input values are
validated.
4)
Exit the Configuration Mode…
OR
Same as for
Enter the Configuration Mode.
5)
The scanner will automatically restart itself…
Same as for
Power on the scanner.
Normal setup
barcode
Normal setup
barcode
Special setup
barcode
Decimal barcodes