Curtiss Wright/Vista Controls QUPID2003 Benutzerhandbuch
The information contained herein is proprietary REVISION 2
information subject to the restrictions stated on the front page.
information subject to the restrictions stated on the front page.
- 3 -
3.0
INSTALLATION PROCEDURES
Unpack sensor with attached antenna reflector and place on clean surface as shown in
Figure 3-1.
Figure 3-1.
Figure 3-1
QUPID Sensor and Folded Antenna Reflector
3.1
Unscrew the captive thumb screws (Figure 3-1, Item 1), one on each side of each
antenna reflector, until the spring on the screw pushes the screw clear of the threaded
hole.
antenna reflector, until the spring on the screw pushes the screw clear of the threaded
hole.
3.2
Carefully unfold antenna reflectors as shown in Figure 3-2, Item 1. At approximately a
30
30
° angle, the mating threaded holes and the thumb screws on the side angle support will
align. Push in on the spring loaded thumb screws, Figure 3-2, Item 2, located on both
sides of each antenna reflector, and tighten.
sides of each antenna reflector, and tighten.
Figure 3-2
Deploy Antenna Reflectors
1
1
1
1
2