Curtiss Wright/Vista Controls QUPID2003 Manual De Usuario

 

The information contained herein is proprietary                                                                                        REVISION 2 
information subject to the restrictions stated on the front page. 

 

 

- 3 -

 

 

 

Unpack sensor with attached antenna reflector and place on clean surface as  shown in 
Figure 3-1. 

 

 

3.1 

Unscrew the captive thumb screws (Figure 3-1, Item 1), one on each side of each 
antenna reflector, until the spring on the screw pushes the screw clear of the threaded 
hole. 

 

3.2 

Carefully unfold antenna reflectors as shown in Figure 3-2, Item 1.  At approximately a 
30

° angle, the mating threaded holes and the thumb screws on the side angle support will 

align.  Push in on the spring loaded thumb screws, Figure 3-2, Item 2, located on both 
sides of each antenna reflector, and tighten.