Hewlett Packard Enterprise Company APIN0344345 Benutzerhandbuch
Electrostatic discharge (ESD)
When handling any electronic component or assembly (such as a PCI card or memory DIMM),
you must observe the following antistatic precautions to prevent damage. An ESD kit (Hewlett
Packard Enterprise P/N A3024-80004) is available (or supplied with memory additions). This kit
contains one wrist strap, one conductive sheet, and one antistatic foam pad.
•
you must observe the following antistatic precautions to prevent damage. An ESD kit (Hewlett
Packard Enterprise P/N A3024-80004) is available (or supplied with memory additions). This kit
contains one wrist strap, one conductive sheet, and one antistatic foam pad.
•
Always disconnect power from the server and wear a grounded wrist strap when working
around the server.
around the server.
•
Always wear a grounded wrist strap when handling printed circuit boards.
•
Treat all assemblies, components, and interface connections as static sensitive.
•
Avoid working in carpeted areas and keep body movement to a minimum while removing
or installing boards to minimize buildup of static charge.
or installing boards to minimize buildup of static charge.
Voltage selection
•
On products that have voltage select switches, make sure that the switch is set for the type
of voltage you use (115 VAC or 230 VAC).
of voltage you use (115 VAC or 230 VAC).
•
Do not attempt to power the product with voltage converter kits sold for appliances.
Batteries
WARNING!
Some Hewlett Packard Enterprise products may contain internal replaceable
battery cells or battery packs. There is risk of fire, burns, or explosion if the battery pack is not
handled properly. To reduce the risk of personal injury:
•
handled properly. To reduce the risk of personal injury:
•
Do not attempt to recharge the battery.
•
Do not disassemble, crush, puncture, short external contacts, or dispose of the battery in
fire or water.
fire or water.
•
Replace only with the Hewlett Packard Enterprise spare battery designated for this product.
Dispose of used batteries according to the manufacturer's instructions and local disposal
requirements.
Dispose of used batteries according to the manufacturer's instructions and local disposal
requirements.
•
For battery holders (for example, coin cells), observe the correct polarity when changing the
battery/cell. There is a danger of explosion if the battery is installed incorrectly.
battery/cell. There is a danger of explosion if the battery is installed incorrectly.
Precautions for power products
11