Hewlett Packard Enterprise Company APIN0344345 Benutzerhandbuch
The total combined leakage current should not exceed 5 percent of the input current
for the UPS and associated load.
for the UPS and associated load.
◦
For rack installations, do not exceed the maximum number of UPS products in any
single equipment rack.
single equipment rack.
◦
For rack installations, install the UPS only at the bottom of a rack.
•
To reduce the risk of personal injury or damage to equipment when installing a Remote
Emergency Power Off (REPO) port:
Emergency Power Off (REPO) port:
◦
The REPO port must be wired by a licensed electrician.
◦
Verify that the main AC power disconnect device for the UPS is locked and/or tagged
in the OFF position before wiring the REPO port.
in the OFF position before wiring the REPO port.
◦
In North America, the REPO circuit must comply with the NEC (NFPA 70, Article 725)
for a Class 2 circuit. In other geographical regions or countries, the REPO port wiring
must comply with the national and local standards in the area in which the product is
installed.
for a Class 2 circuit. In other geographical regions or countries, the REPO port wiring
must comply with the national and local standards in the area in which the product is
installed.
•
To reduce the risk of personal injury from electric shock or damage to equipment when
installing or servicing batteries:
installing or servicing batteries:
◦
Make sure that only trained service personnel handle or connect the batteries.
◦
Remove watches, rings, or other metal objects prior to working with the equipment.
◦
Use tools with insulated handles.
◦
On products with remote external batteries, do not attempt to replace batteries unless
all battery circuit breakers are in the OFF (down) position. These are hazardous voltage
batteries.
all battery circuit breakers are in the OFF (down) position. These are hazardous voltage
batteries.
•
This product may contain sealed lead-acid or lithium-ion batteries. To reduce the risk of fire
or chemical burns:
or chemical burns:
◦
Do not attempt to recharge batteries after they have been removed from the equipment.
◦
Do not disassemble, crush, or puncture the batteries.
◦
Do not short the external contacts of the batteries.
◦
Do not immerse the batteries in water.
◦
Do not expose the batteries to temperatures higher than 60°C or dispose of in fire.
◦
Use only the Hewlett Packard Enterprise spare battery designated for this equipment.
Power distribution units (PDUs)
To reduce the risk of electric shock and/or equipment damage when installing or servicing PDUs:
•
•
The installation and routine maintenance and service of PDUs must be performed by trained
service technicians who are knowledgeable about the procedures, precautions, and hazards
associated with AC power products.
service technicians who are knowledgeable about the procedures, precautions, and hazards
associated with AC power products.
•
Hardwired PDUs require a direct connection to an AC branch circuit (AC mains). Connection
should only be performed in accordance with National Electrical Code (NFPA70 Article 310)
in North America, or in other regions or countries, in accordance with the equivalent local
and national wiring regulations.
should only be performed in accordance with National Electrical Code (NFPA70 Article 310)
in North America, or in other regions or countries, in accordance with the equivalent local
and national wiring regulations.
Precautions for power products
9