Hewlett Packard Enterprise Company APIN0344345 Benutzerhandbuch
•
Do not use conductive tools that could bridge live parts.
•
Remove all watches, rings, or loose jewelry when working in hot-plug areas of an energized
server, storage, networking, or rack product.
server, storage, networking, or rack product.
•
Do not attempt to defeat safety interlocks (where provided).
•
Some products have covers or doors to access hot-plug components and may allow access
to hazardous energy circuits or moving fans.
to hazardous energy circuits or moving fans.
◦
The doors should remain locked during normal operation.
OR
◦
The server, storage, networking, or rack product should be installed in a controlled
access location where only qualified personnel have access.
access location where only qualified personnel have access.
•
Power down the equipment and disconnect all power cords before removing any access
covers for non-hot-plug areas.
covers for non-hot-plug areas.
•
Do not replace non-hot-plug components while power is applied to the product. First, shut
down the product and disconnect all power cords.
down the product and disconnect all power cords.
•
Do not exceed the level of repair specified in the procedures in the product documentation.
All troubleshooting and repair procedures are detailed to allow only subassembly or
module-level repair. Because of the complexity of the individual boards and subassemblies,
do not attempt to make repairs at the component level or to make modifications to any printed
wiring board. Improper repairs can create a safety hazard.
All troubleshooting and repair procedures are detailed to allow only subassembly or
module-level repair. Because of the complexity of the individual boards and subassemblies,
do not attempt to make repairs at the component level or to make modifications to any printed
wiring board. Improper repairs can create a safety hazard.
•
For floor-standing products, install and extend bottom stabilizers before installing options
and boards.
and boards.
•
Verify that the AC power supply branch circuit that provides power to the rack is not
overloaded. This will reduce the risk of personal injury, fire, or damage to the equipment.
The total rack load should not exceed 80 percent of the branch circuit rating. Consult the
electrical authority having jurisdiction over your facility wiring and installation requirements.
overloaded. This will reduce the risk of personal injury, fire, or damage to the equipment.
The total rack load should not exceed 80 percent of the branch circuit rating. Consult the
electrical authority having jurisdiction over your facility wiring and installation requirements.
Precautions for power products
Power cords
To reduce the risk of electric shock or damage to the equipment:
•
•
Use an approved power cord. If you have questions about the type of power cord to use,
contact your Hewlett Packard Enterprise authorized service provider.
contact your Hewlett Packard Enterprise authorized service provider.
•
If you have not been provided with a power cord for your product or for any AC-powered
option intended for your product, purchase a power cord that is approved for use in your
country.
option intended for your product, purchase a power cord that is approved for use in your
country.
•
You must use a power cord rated for your product and for the voltage and current marked
on the electrical ratings label of the product. The voltage and current rating of the cord must
be greater than the voltage and current rating marked on the product.
on the electrical ratings label of the product. The voltage and current rating of the cord must
be greater than the voltage and current rating marked on the product.
•
Do not place objects on AC power cords or cables. Arrange them so that no one may
accidentally step on or trip over them.
accidentally step on or trip over them.
•
Do not pull on a cord or cable. When unplugging from the electrical outlet, grasp the cord
by the plug.
by the plug.
•
Make sure that the total ampere rating of all products plugged into an extension cord or
power strip does not exceed 80 percent of the ampere ratings limit for the extension cord or
power strip.
power strip does not exceed 80 percent of the ampere ratings limit for the extension cord or
power strip.
Precautions for power products
7