SendFar Technology Co. Ltd. OAP-04003 Benutzerhandbuch

Seite von 32
 
 
58
B-1-12 Software Upgrade (as shown in Table B-12) 
 Parameter 
 Description 
Default Value 
 TFTP Server IP 
 Address 
 Specify the IP address of the  
 TFTP server to upgrade the  
 firmware of the AP 
192.168.2.100 
 Upgrade Filename 
 Specify the filename of 
 requested firmware 
 stored in TFTP server 
soho.bin 
Table B-12 
 
 
59
Chapter 7.  Regulatory Compliance Information 
 
Radio Frequency Interference Requirements 
This device complies with Part 15 of FCC Rules and Canada RSS-210. 
Operation is subject to the following conditions: 
This device may not cause harmful interference. 
This device must accept any interference received, including interference 
that may cause undesired operation. 
 
Radiation Exposure Statement 
This equipment complies with FCC radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated 
with minimum distance 20 cm between the radiator & your body. 
 
This transmitter must not be co-located or operating in conjunction with any 
other antenna of transmitter. 
 
Interference Statement 
This equipment has been tested and found to comply with the limits for a 
Class B digital device pursuant to Part 15 of the FCC Rules and Regulation. 
These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and 
can radiate radio frequency energy and, if not installed and used in 
accordance with the instruction manual, may cause harmful interference to 
nearby TV’s, VCR’s, radio, computers, or other electronic devices. To 
minimize or prevent such interference, this equipment should not be placed 
or operated near these devices. If interference is experienced, moving the 
equipment away from them will often reduce or eliminate the interference. 
 
However, there is no guarantee that interference will not occur in a particular 
installation. If the equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or 
more of the following measures: 
Re-orient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that which the 
receiver is connected. 
Consult the dealer or an experienced radio/TV technician for help.