Lee Technology Korea Co. Ltd. LTK-25 Benutzerhandbuch

Waitercall 25 transmitter User’s manual

Thank you for purchasing LEETEK’s Waitercall 25 paging system. Your system has been

Pre-programmed at the factory and will function once mounted and plugged in.

SYSTEM PROGRAMMING MENU

*All programming should be done from the main terminal if an additional / cancel panel is used.

1. To enter programming mode plug in the Unit while holding the 3X button

2. You will see the numbers 1 – 12 either flashing, solid Red or Solid Green

3. The menu is as follows:

#1 = Set the Current Time (hours, minutes & am or pm)

#2 = Set the Sleep Shutdown Time (hourly 1-12, am or pm) *

*Be sure the times are set correctly or your pagers could go to sleep in the middle of a
shift!

#3 = Sleep Shutdown Green = Active, Red = Inactive

#4 = Page the Manager Green = Page Manager on Blinking Red, Red – No Manager

page

#5 = Page on Transition Green = Page Waiter on First Button press and all color

transitions Red = Waiter paged only on the first press

#6 = Set transition timers - how long between green to yellow to red transition

#7 = Not used

#8 = Not used

#9 = Not used

#10=Not used

#11=Not used

#12=Simple Page Green = Page waiter on first button press only.

4. To save the configuration at any time, hit the x3 button while at the top-level menu.

Programming & Configuration Instructions

To enter the programming mode, plug in the Unit while holding the X3 button. You will see the numbers 1
–

12 either flashing, solid Red or Solid Green. After setting the configuration below, press X3 button to save all the

settings.

1. Set the Current Time Menu

The numbers 1-12 can be pressed to correspond to the hours of the day. After pressing #1, press

1-12 to adjust the hour. To set the minutes, press either the #13 button (to scroll up) or #14 (to scroll

down). Use the flashing all sleep button to toggle between am & pm. The dot on the top middle portion

of the LCD indicates PM. (If the dot is there it’s pm; if there is no dot it is am) Note that this current time must

be set in order to have an accurate sleep shutdown.

Press the x3 button to exit this menu.

2. Set the Sleep Shutdown Time Menu

The numbers 1-12 can be pressed to correspond to the hours of the day. After pressing #2, press

1-12 for the hour you want the pagers to turn off for the night and use the flashing all sleep button to

toggle between am & pm. The dot on the top middle portion of the LCD indicates PM. (If the dot is there it’s

pm; if there is no dot it is am) Press the x3 button to exit the menu and set the time. Note that when the

internal clock reaches this time, all the pagers will be put to sleep.