Airaya Corp GRID-3X3-PS Benutzerhandbuch

Airaya

 

- 37 - 

Airaya

  

Proven, Fast and Affordable Outdoor Wireless Bridges

 

If you receive ping responses from both test stations, the network IP configuration and 
physical wiring is working properly between the 2 test stations using Ethernet.  If you 
cannot ping both test stations, check your Ethernet cable connections and test station 

network settings to verify they are configured properly.    
 
 
 
  

 
When ping works properly with wired test stations, go to Step 2. 
 
 

Step 2. Setup wired Ethernet network connections to bridges   

 
Connect directly using straight-thru cables, or through network switches or routers using 
straight-thru Ethernet cables.  
 

 

 

1. 

Start a continuous ping from test Station A to bridge end point A.  To start a 
continuous ping using the factory default IP settings of the bridge, type the 

following into a DOS or CMD window on test station A:   

 

WirelessGRID products shipped as complete kits have one bridge factory-configured with IP address 192.168.1.70, and one 
bridge factory-configured with IP address 192.168.1.71.  Both bridges have a default subnet mask of 255.255.255.0 
1000 Mbps full duplex (gigabit) ports are best from connecting bridges to wired Ethernet networks. 

If ping does not work between 2 wired test stations, it will not work between 2 test stations connected by a WirelessGRID link.