Avante International Technology Inc. VT-EVC308-FF Benutzerhandbuch

 

 

 

Full-face Polling Official’s Manual Version 1.1.2                       December 28, 2005 
©2001-2005 Avante International Technology, Inc.

 

 

 

4 

Figure 3.1A shows the front view of a full-face voting unit.  

 

 

 

 

 

 

 

 

 

 

 

The voting unit is attached to an electric-powered height-adjustable table with four articulating 

wheels (omni-directional). A compartment that contains power-control components and batteries 

sits at the rear bottom of the table. The power cord of the entire voting unit is stored inside this 

compartment. You need to plug the power cord into the power outlet before operating the voting 

machine. Depending on the required duration of power backup, an additional battery 

compartment may be mounted at the front bottom of the table.  

 

The front side of the voting machine contains the monitor, and the printer unit that is mounted to 

the right of the monitor. A smart card reader slot is located at the lower right corner of the 

monitor unit, and a headphone jack is located at the lower left corner of the monitor. The printer 

unit is used to print all the reports (including the Voter-Verifiable Paper Audit Trail) that are 

required during the voting session. The power and data wiring for the printer has been pre-

installed so that you do not need to plug in anything to the printer.