Avante International Technology Inc. VT-EVC308-FF Manual Do Utilizador
Full-face Polling Official’s Manual Version 1.1.2 December 28, 2005
©2001-2005 Avante International Technology, Inc.
©2001-2005 Avante International Technology, Inc.
4
SET UP THE VOTING UNIT
1.1 GET FAMILIAR WITH THE VOTING UNIT
Figure 3.1A shows the front view of a full-face voting unit.
The voting unit is attached to an electric-powered height-adjustable table with four articulating
wheels (omni-directional). A compartment that contains power-control components and batteries
sits at the rear bottom of the table. The power cord of the entire voting unit is stored inside this
compartment. You need to plug the power cord into the power outlet before operating the voting
machine. Depending on the required duration of power backup, an additional battery
compartment may be mounted at the front bottom of the table.
The front side of the voting machine contains the monitor, and the printer unit that is mounted to
the right of the monitor. A smart card reader slot is located at the lower right corner of the
monitor unit, and a headphone jack is located at the lower left corner of the monitor. The printer
unit is used to print all the reports (including the Voter-Verifiable Paper Audit Trail) that are
required during the voting session. The power and data wiring for the printer has been pre-
installed so that you do not need to plug in anything to the printer.
Figure 3.1A