Extreme networks OAP36C Benutzerhandbuch
WS-AP3660 Installation Procedures
Installation
Enterasys Wireless Outdoor WS-AP3660 Installation Guide
2-7
2.
Feed the supplied stainless steel tie back straps through the openings in the mounting bracket
(see
(see
).
Figure 2-5
Attaching Straps to the Mounting Bracket
3.
Feed the free end of the strap around the pole.
4.
Tighten the tensioning screw to adapt the strap to the diameter of the pole.
Attaching Antennas
To attach external antennas to the WS-AP3660:
1.
Connect an LMR cable (with Reverse Polarity Type-N plugs on both ends) to an antenna
connector on the WS-AP3660 (see
connector on the WS-AP3660 (see
2.
Connect the antenna to the LMR cable.
3.
Place a terminator cap on any antenna connector(s) that will not be used (see
1
Mounting bracket (horizontal position)
2
Stainless steel straps (X2)
Notes: The total number of required antennas and associated port locations on the WS-AP3660 is
dependant on the coverage area and the type of antennas selected.
dependant on the coverage area and the type of antennas selected.
Note: The following antennas do not require an LMR cable and can be directly connected to the
WS-AP3660: WS-AO-DT05120-1 and WS-ANT21. See “
WS-AP3660: WS-AO-DT05120-1 and WS-ANT21. See “
page 2-2, for a complete list of available antennas and cables.