Renishaw plc RMIV2 Benutzerhandbuch

RMP60-RMI partnership

continued on next page

System setup is achieved using trigger logic

and powering on the RMI.

Trigger logic is a method that allows user

configuration of the options available in the

RMP60. Trigger logic uses a sequence of

RMP60 triggering and battery insertion

followed by further RMP60 triggering.

This leads the user through a series of choices

allowing selection of the required options.

Reviewing of choices can be made by battery

insertion alone. See RMP60 user’s guide for

full details of reviewing probe settings.

Partnering is only required during initial system

set-up. Further partnering is only required if

either the RMP60 or RMI is changed.

Partnering cannot be lost by reconfiguration

of probe settings or when changing batteries.

Partnering can take place anywhere within

the operating envelope.

1. Use trigger logic to access RMP60

configuration mode.

2. Configure turn on method (if not configured).

3. Configure turn off method (if not configured).

4. Enter acquisition mode by deflecting stylus.

5. Remain in acquisition mode off by not

releasing stylus. This allows time to get the

RMI ready for partnering.

6. Power on RMI.

7. Watch the RMI signal LED; after a couple

of seconds the LED will repeatedly flash

on and off green. This is the start of a

10 second interval in which the RMI

is in acquisition mode.

8. Release RMP60 stylus and trigger a

couple of times. This causes the RMP60

to go into (and out of) acquisition mode.