ADC Telecommunications Inc. F0694-011 Benutzerhandbuch

5-5

CONFIDENTIAL

The RAU has one female type-N connector. The connector is a duplexed RF 
input/output port that connects to a standard 50

Ω passive antenna using coaxial cable.

The RAU has one type-F female connector that connects it to a Fusion Wideband 
Hub using CATV 75 Ohm cable. Use RG-59, 6, or 11 solid copper center conductor 
cables.

NOTE: For system performance, it is important that you use only low loss, 
solid copper center conductor CATV cable with quality F connectors that use 
captive centerpin conductors. Refer to Appendix A for specific information.

Upon power up, the RAU goes through a two-second test to check the LED lamps. 
During this time, the LEDs blink green/green red/red, letting you visually verify that 
the LED lamps and the firmware are functioning properly.

NOTE: Refer to Section 9 for troubleshooting using the LEDs.

The RAU status LEDs can be in one of the states shown in Table 5-3. These LEDs 
can be:

off

steady green

steady red

There is no off state when the unit’s power is on.