Adtran TRC4106L2 Benutzerhandbuch

Section 5  User Interface Guide

TRACER 4106/4206 System Manual

 52

© 2004 ADTRAN, Inc.

612804206L2-1A

Configures the T1 for the appropriate line buildout, based on the distance to the T1 equipment. By default, 
the line buildout for the TRACER 4106/4206 is 

.

Determines whether the TRACER 4106/4206 unit will report active alarms. If set to 

, no alarms will 

be displayed on this menu page. The 

 parameter is independently configured for the local 

and remote TRACER 4106/4206 units. When set to 

, the front panel LED alarms are also disabled 

(OFF). By default, alarm reporting is set to 

.

Configures the framing format for the T1 link for both the local and remote TRACER 4106/4206 units. The 
TRACER 4106/4206 transports T1 data across the link (as long as the T1 signal is properly timed). Configure 
the framing format (using the 

 menu) to enable the TRACER 4106/4206 to monitor incoming 

framing error events and indicate problems with the attached metallic service. The TRACER 4106/4206 
supports both extended superframe (

) and superframe (

) framing formats. By default, the signaling 

method is set to 

.

Sets the line coding for the T1 link. The TRACER 4106/4206 supports bipolar eight-zero substitution (

and alternate mark inversion (

) line coding. By default, the line code is set to 

.

Controls the loop status of the T1 link. Activates/deactivates loopback conditions for testing purposes.

Defines the T1 link as normal data transport mode - there are no active loopbacks.

Activates a loopback at the local TRACER 4106/4206 T1 framer towards the remote end of the wireless link 
(see Figure 9). Use the local 

 loopback to loop the data transmitted from the remote end of the link back 

across the radio link to the remote end of the link. This loopback tests the integrity of the radio link and all the 
associated digital and RF hardware.