Braemar Manufacturing LLC FUSION Benutzerhandbuch
Fusion Wireless Recorder
13
Establishing the Home Link
In accordance with FDA directive, Fusion Wireless Monitoring with
patient alarm conditions requires the establishment of a Home Link
alternative to cellular data communications. The Fusion Recorder kit
contains Bluetooth wireless hardware that must be connected to a normal
RJ-11C telephone jack, typically located on the nightstand or where the
patient will spend most of their time during the procedure. Patients
inside the home location should be in Home Link wireless contact if they
are within approximately 100 feet of the system. Note: This modem has
an actual line of site range of 328 feet but due to walls and other
structural impedance the modem should be placed within 100 feet. After
installation of the Home Link, the patient will contact the monitoring
center to verify that the redundant data transfer system is functioning.
patient alarm conditions requires the establishment of a Home Link
alternative to cellular data communications. The Fusion Recorder kit
contains Bluetooth wireless hardware that must be connected to a normal
RJ-11C telephone jack, typically located on the nightstand or where the
patient will spend most of their time during the procedure. Patients
inside the home location should be in Home Link wireless contact if they
are within approximately 100 feet of the system. Note: This modem has
an actual line of site range of 328 feet but due to walls and other
structural impedance the modem should be placed within 100 feet. After
installation of the Home Link, the patient will contact the monitoring
center to verify that the redundant data transfer system is functioning.
The Fusion Recorder and Home Link modem wireless connection are
already preset by the Braemar factory.
already preset by the Braemar factory.
Follow the directions provided with the Home Link hardware to connect
the modem to the patient’s telephone line. After installation of the Home
Link, the patient will contact the monitoring center to verify that the
redundant data transfer system is functioning.
the modem to the patient’s telephone line. After installation of the Home
Link, the patient will contact the monitoring center to verify that the
redundant data transfer system is functioning.
Fusion Wireless Recorder
14
Patient Operating Instructions
The Recorder should be ready when you receive it from the technician.
If there are any problems, refer to the Troubleshooting section.
Display overview:
If there are any problems, refer to the Troubleshooting section.
Display overview:
To Hookup:
1. Snap lead wires onto electrodes first, and then apply electrodes
according to physician instructions.
2. Reapply fresh electrodes daily.
3. Insert the Patient Cable into the Recorder.
4. The Recorder is now recording data as seen in the above screenshot.