Honeywell International Inc. THM4000R02 Benutzerhandbuch
3
69-2426—01
3
Link all devices to wireless network
1 Remove cover from wireless receiver.
2 Verify POWER light is solid green.
3 Press and release the CONNECT button.
4 If CONNECT light does not flash, another
2 Verify POWER light is solid green.
3 Press and release the CONNECT button.
4 If CONNECT light does not flash, another
receiver or RedLINK wireless adapter may be in
wireless setup mode. Exit wireless setup at the
other device.
wireless setup mode. Exit wireless setup at the
other device.
M28925
Wireless Setup
Next
M32308
Connect
Back
Wireless Setup
M32307
Done
Connected
Wireless Setup
Link remote controller to wireless network
Zone name
Press s or t to change the name or location of this zone,
then press
then press
NEXT.
Example: 67 = Meeting Room
See complete zone list on page 8.
Press
CONNECT to establish a link to the wireless network.
If E0 or E1 appears, see error codes on page 10.
After a brief pause, the confirmation screen at left should
be displayed to verify that the wireless connection has been
established.
be displayed to verify that the wireless connection has been
established.
Press
DONE to display the home screen.
POWER LED
Solid Green: Powered and communication
Solid Green: Powered and communication
is established.
Slow Flashing Green (1 flash/
second): Receiver is powered.
Wait approximately 30 seconds for
communication to be established
between the wireless receiver and the
indoor unit. Check cable connection if
flashing does not stop after 30 seconds.
Wait approximately 30 seconds for
communication to be established
between the wireless receiver and the
indoor unit. Check cable connection if
flashing does not stop after 30 seconds.
Fast Flashing Green (5 flashes/second):
Error in communication between
wireless receiver and the indoor unit.
Check cable connection.
wireless receiver and the indoor unit.
Check cable connection.
CONNECT LED
Flashing Green: In wireless setup
Flashing Green: In wireless setup
mode.
Solid Green: RedLINK communication
is established.
Yellow: Please wait.
Red: RedLINK device is not
Red: RedLINK device is not
communicating.
Flashing status light times out
after 15 minutes of inactivity. Press
CONNECT again if necessary.
after 15 minutes of inactivity. Press
CONNECT again if necessary.