Honeywell International Inc. THM4000R02 用户手册

1  Remove cover from wireless receiver.
2  Verify POWER light is solid green.
3  Press and release the CONNECT button.
4  If CONNECT light does not flash, another

receiver or RedLINK wireless adapter may be in 
wireless setup mode. Exit wireless setup at the
other device.

M28925

M32308

M32307

Connected

Zone name

Press s or t to change the name or location of this zone, 
then press 

NEXT.

Example: 67 = Meeting Room

See complete zone list on page 8.

Press

CONNECT to establish a link to the wireless network.

If E0 or E1 appears, see error codes on page 10.

After a brief pause, the confirmation screen at left should 
be displayed to verify that the wireless connection has been 
established.

Press

DONE to display the home screen.

POWER LED
Solid Green: Powered and communication

is established.

second): Receiver is powered. 
Wait approximately 30 seconds for
communication to be established 
between the wireless receiver and the 
indoor unit. Check cable connection if 
flashing does not stop after 30 seconds.

Fast Flashing Green (5 flashes/second): 

Error in communication between 
wireless receiver and the indoor unit. 
Check cable connection.

CONNECT LED
Flashing Green: In wireless setup 

mode.

Solid Green: RedLINK communication 

is established.

Yellow: Please wait.
Red: RedLINK device is not 

communicating.

Flashing status light times out
after 15 minutes of inactivity. Press
CONNECT again if necessary.