Image Sensing Systems Inc. SX300AN Benutzerhandbuch
Chapter 2:
Placement in Midblock Applications
RTMS Sx-300 User Guide
©2014 Image Sensing Systems Inc.
2-12
Placement in Midblock Applications
Placement in Midblock application is similar to Side-fired Highway. If sufficient
setback is available, up to 12 zones of traffic can be configured. If the Autoscope
RTMS Sx-300 is mounted in a zero setback configuration, only the nearest four zones
are available for detection; however, the nearest zones can be excluded from detection
(creating adequate sensor setback) if data from zones farther away is desired. The
installer should verify which intersection approaches are most critical to proper data
collection and configure the Autoscope RTMS Sx-300 to capture information from
these lanes of traffic.
setback is available, up to 12 zones of traffic can be configured. If the Autoscope
RTMS Sx-300 is mounted in a zero setback configuration, only the nearest four zones
are available for detection; however, the nearest zones can be excluded from detection
(creating adequate sensor setback) if data from zones farther away is desired. The
installer should verify which intersection approaches are most critical to proper data
collection and configure the Autoscope RTMS Sx-300 to capture information from
these lanes of traffic.
Figure 2-14: Midblock Placement
Mounting and Aiming Procedure
Warning
!
Installation of Autoscope RTMS Sx-300 hardware may require that you work
above the ground on a ladder or bucket truck. Please make sure you have all the
required equipment and are aware of potential safety issues before starting any
installation. DO NOT install any Autoscope RTMS Sx-300 hardware if you are
unsure how to complete the installation or lack appropriate safety equipment. It
is recommended that you do NOT install this hardware during inclement
weather.
above the ground on a ladder or bucket truck. Please make sure you have all the
required equipment and are aware of potential safety issues before starting any
installation. DO NOT install any Autoscope RTMS Sx-300 hardware if you are
unsure how to complete the installation or lack appropriate safety equipment. It
is recommended that you do NOT install this hardware during inclement
weather.
The following equipment is required to mount and aim the Autoscope RTMS Sx-300
unit:
unit:
•
Provided: Autoscope RTMS Sx-300 unit, bracket, washers, nut and bolts (for
brackety only) and connectors or optional pre-made Autoscope RTMS Sx-300
cable.
brackety only) and connectors or optional pre-made Autoscope RTMS Sx-300
cable.
•
Not Provided: Bolts or stainless steel banding to mount to a pole. The bolt
specifications depend on the mounting requirements: for example, different
bolts may be required when the Autoscope RTMS Sx-300 unit is mounted on
a wooden pole than when the Autoscope RTMS Sx-300 unit is mounted on a
specifications depend on the mounting requirements: for example, different
bolts may be required when the Autoscope RTMS Sx-300 unit is mounted on
a wooden pole than when the Autoscope RTMS Sx-300 unit is mounted on a