Trimble Inc. 6248192-B1 Benutzerhandbuch
F Troubleshooting
116 SPSx80 Smart GPS Antenna User Guide
Base station setup and static measurement problems
This section describes some possible station setup and static measurement issues,
possible causes, and how to solve them
possible causes, and how to solve them
.
Trimble recommends that you use the SCS900 software to restart or configure base
and rover receivers. The SCS900 software sets up all radio and receiver operating
parameters, and is the most likely route to a successful problem resolution once you
have checked all connections, cables, and batteries.
and rover receivers. The SCS900 software sets up all radio and receiver operating
parameters, and is the most likely route to a successful problem resolution once you
have checked all connections, cables, and batteries.
The receiver is not
responding.
responding.
Receiver needs a soft reset.
Turn off the receiver and then turn it
back on again.
back on again.
Receiver needs a full reset.
Press
E
for 30 seconds.
Note – To retain data files, remove
the CompactFlash card (SPS770) or
download the files (SPS780) first.
the CompactFlash card (SPS770) or
download the files (SPS780) first.
Issue
Possible cause
Solution
Base station is not
broadcasting.
broadcasting.
Port settings between base
receiver and external radio
are incorrect.
receiver and external radio
are incorrect.
Note – The SPS770 has an
integrated RX only radio. For
use as a base station, the
receiver must be connected to
an external radio, such as a
TRIMMARK™ 3.
integrated RX only radio. For
use as a base station, the
receiver must be connected to
an external radio, such as a
TRIMMARK™ 3.
Note – The SPSx80 has the
option for an integrated TX
radio that allows it to be used
without an external radio at
the base and rover location.
The SPSx80 can also be
connected to an external high
power radio in certain
countries.
option for an integrated TX
radio that allows it to be used
without an external radio at
the base and rover location.
The SPSx80 can also be
connected to an external high
power radio in certain
countries.
Using the Trimble SCS900 Site
Controller software connect to the
radio through the receiver. If no
connection is made, connect directly
to the radio and change the port
settings. Try to connect through the
receiver again to ensure that they
are communicating.
Controller software connect to the
radio through the receiver. If no
connection is made, connect directly
to the radio and change the port
settings. Try to connect through the
receiver again to ensure that they
are communicating.
Note – The SCS900 software does
not support direct connection to the
external radio; it only allows
configuration through the receiver.
The TRIMMARK 3 and SNB900 radios
can be configured directly using the
keypad and display. The Trimble PDL
or Trimble HPB radios can be
configured using the accompanying
configuration software through a
laptop computer.
not support direct connection to the
external radio; it only allows
configuration through the receiver.
The TRIMMARK 3 and SNB900 radios
can be configured directly using the
keypad and display. The Trimble PDL
or Trimble HPB radios can be
configured using the accompanying
configuration software through a
laptop computer.
Faulty cable between receiver
and external radio
and external radio
•
Try a different cable
•
Examine the ports for missing
pins
pins
•
Use a multimeter to check the
pins
pins
No power to radio
If the radio has its own power
supply, check the charge and
connections.
supply, check the charge and
connections.
No Bluetooth connections
(SPS780 / SNB900)
Make sure that the radio and
receiver are within Bluetooth range
of each other and that the Bluetooth
antennae are visible to each other.
receiver are within Bluetooth range
of each other and that the Bluetooth
antennae are visible to each other.
Issue
Possible cause
Solution