Trimble Inc. 6248192-B1 Benutzerhandbuch

SPSx80 Smart GPS Antenna User Guide     

Troubleshooting     

Roving receiver is not 
receiving radio from 
the base station.

The base station is not 
broadcasting.

See 

Base station is not broadcasting.

Incorrect over air baud rates 
between base station and 
rover.

Connect to the roving receiver’s 
radio and make sure that it has the 
same setting as the base station 
receiver.

Mismatched channel or 
network number selection.

Match the base station and rover 
radio channels/network number and 
try again.

Incorrect port settings 
between the rover external 
radio and receiver.

If the radio is receiving data (the 
Radio LED is flashing) and the 
receiver is not receiving data, check 
the port settings of the receiver and 
radio using the Trimble SCS900 Site 
Controller software; match the 
settings and try again.

The radio antenna cable and 
GPS antenna cable are mixed 
up.

Make sure that the radio antenna 
cable (with the blue over-mould) is 
connected between the blue TNC 
connector marked RADIO and the 
radio antenna.