Forward Electronics Co Ltd 4K3FDM-M31-H Benutzerhandbuch

4D RF Hand Track User Guide

* NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR

 TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO

  THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S

 AUTHORITY TO OPERATE THE EQUIPMENT.

* FCC Requirements Radio & Television Interference

Warning: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy, and if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

1).Reorient or relocate the receiving antenna.

2).Increase the distance between the equipment and receiver.

3).Connect the equipment into a separate power outlet from which the receiver is

connected.

4).Consult the dealer or an experienced radio/TV technician for solution.

Note:

1. The changes or modifications not expressly approved by the party responsible for

compliance could void the user authority to operate the equipment.

2. Shielded interface cable and A.C. power cord, if any, must be used in order to

comply with the emission limits.

Hardware Installation

1.  Install the Batteries

1).Remove the battery compartment cover.

2).Insert batteries. Follow the diagram inside the battery compartment.

3).Replace cover.

2.  Connect the Receiver

1).For installation on a PS/2 mouse port, turn off your system. Connect the

receiver cable to the PS/2 mouse port on your computer, then turn on your

system.