Forward Electronics Co Ltd 4K3FDM-M31-H Benutzerhandbuch

2).For USB-port installation (Windows 98 or higher required, or Macintosh OS

8.6 or higher required), remove the PS/2 adapter, connect the receiver cable to

the USB port on your computer. For Windows, you may be prompted to insert

the Windows software CD. Insert this CD into the CD-ROM drive, then follow

the on-screen instructions.

3.

Making a connection between radiator and receiver

Press the ID red connect button on the Receiver, then press the Red connect

button on the Radiator to transfer the signal to the receiver.

4.

Recharging your battery

Your RF Hand Track has a function for recharging battery. This function can be

used on the rechargeable battery only. Any other type of battery is not suitable

for this function.

Refer to the following steps to re-charge your NiMH rechargeable battery.

1).Load in your NiMH rechargeable batteries according to the diagram inside the

battery compartment.

2).Release the power cable under the receiver and plug it into the bottom of your

RF Hand Track.

3).You can operate the RF Hand Track as normal while the batteries are in

charging.

The RF Hand Track does not work after installation or is not detected

1. Make sure you have connected the receiver correctly. The receiver cable goes into

the computer’s USB port or PS/2 mouse port. For optimal performance, place the

receiver at least 8 inches or 20 centimeters away from other electrical devices, such

as the computer, the computer monitor, or external storage devices.

2. For PCs, make sure the PS/2 mouse port has the proper configuration. Refer to your

computer documentation for the correct port configuration. You may also have

other system devices that conflict with the mouse. Check the IRQ/address settings

of these devices for conflicts, and change the settings as required.

3. Establish communication between the receiver and the radiator. Press the connect

button on the receiver, then press the connect button on the radiator.

4. Make sure you have installed the batteries correctly and power has been switched

on.