Digital Security Controls Ltd. 005132 Benutzerhandbuch

3

This section describes how to set up and wire the PC5132 module.

Check that the following parts are in your PC5132 package:

· PC5132 PCB
· PC5132 plastic cabinet

NOTE: Mount the PC5132 receiver and wireless devices after you have done
placement tests with the wireless devices (see sections 5.1 and 5.2).

Find a place that is:

• Dry
• Central to the proposed placement of all wireless devices
• As high as possible
• Far from sources of interference, including: electrical noise such as

computers, televisions and electric motors in appliances and heating and
air conditioning units; large metal objects like heating ducts and plumbing
which may shield the antenna.

Make sure that electrical wires will not run over the antenna(s) of the module
when it is mounted.

When mounting the PC5132 in a basement, place the module as high and as
close to the underside of the first floor as possible. The range of the module will
be reduced if the unit is mounted below ground level.

The antennas have been installed at the factory.
They do not need any adjustment.

CAUTION: Remove all power from the system while connecting modules to the
Keybus.

Connect the PC5132 to the four-wire
Keybus of the control panel according
to the following diagram.

After you have completed the wiring,
reconnect the power to the security
system.

Now that you have wired the PC5132,
you should enroll and program the
wireless devices. See section 3 for
instructions.

PC5132 Set up & Wiring