Digital Security Controls Ltd. 09GS260L Benutzerhandbuch

13

Establishing a communication channel between the Communicator and the panel is critical to ensuring the desired operation of the 
two units. These steps must be undertaken prior to Connect 24 activation.

1

. Wire the telephone line, if available.

2

. Wire the PC9155 panel (but not the Communicator).

3

. Turn on the PC9155 panel. Program the panel’s telephone number, account code, format, GS / IP module enable, and the 

communication path priority (i.e. PSTN > Ethernet > GRPS).

4

. Turn off the panel.

5

. Wire the Communicator through the PC-Link.

6

. Proceed to CONNECT 24 Activation Information below.

Only authorized dealers can activate a TL260GS/TL265GS/GS2060/GS2065 Communicator with CONNECT 24. Dealer appli-
cation forms and additional information on the CONNECT 24 Voice Response Unit can be found at the CONNECT 24 web site 
www.connect24.com. Please contact CONNECT 24 at the number below for assistance:

•

First activate your SIM Card.

•

Your SIM card must be activated with Connect 24 prior to use. Please call the GS Voice Response Unit (GVRU) at least 24 
hours prior to installation at 1-866-910-3865.

•

Initialize the Communicator with Connect 24.

Call the GVRU (GS Voice Resonse Unit) at the toll-free number. Follow the voice prompts and enter in your profile number, 
installer ID number, installer PIN number and central station number. Ensure all information is available before calling the GVRU. 
All this information can be found in your GVRU Activation Package.

7

. Turn on the panel. Wait for the initialization of the Communicator.

For installation of the TL260GS/TL265GS/GS2060/GS2065 Communicator, the local installer is responsible for module pro-
gramming. See Compatibility on page 12 for more information.

1. Assemble the Communicator

• Connect the supplied 12.7cm (5”) antenna cable to the radio by inserting the connector through to the Communicator board 

from the back of the bracket, and then pushing the connector firmly into the socket on the Motorola radio.

• Remove the gold nut and the first nylon washer (washer A) from the threaded section on the cable. Insert the threaded section 

through and replace the washers and nut. Tighten the assembly by hand.

• Remove the four white plastic standoffs from their bag in the Communicator kit.
• Insert the standoffs in through the back of the supplied bracket, using the four holes provided for that purpose located at each 

of the four corners of the bracket.

• Place the bracket on a solid surface. Grasping the edges of the PCB, keeping the board face up, orient the four holes on the 

PCB with the four standoffs protruding from the bracket. Push the PCB firmly and evenly onto the standoffs until the PCB is 
secured to the bracket.