HM Electronics Inc HS500 Benutzerhandbuch
7
4. Headset Operating -Mode Settings
Most stores have installed systems with Hands-Free capability,
but some have not. If you are uncertain whether or not your
System 500 has Hands-Free capability, do the following test.
System 500 has Hands-Free capability, do the following test.
a. Auto-Hands -Free Setting
The auto-hands-free (AHF) feature allows one operator to
communicate with a customer in one drive -thru lane without
pressing any buttons. Other operators can listen. If the
first operator turns the AHF feature off, another operator
can turn it on.
CAUTION: Only one HS500 per lane can be set in the auto-
communicate with a customer in one drive -thru lane without
pressing any buttons. Other operators can listen. If the
first operator turns the AHF feature off, another operator
can turn it on.
CAUTION: Only one HS500 per lane can be set in the auto-
hands-free mode, or interference will occur when a customer
enters the drive-thru lane.
• With the power already on, press and hold the Power button and
enters the drive-thru lane.
• With the power already on, press and hold the Power button and
touch the Volume-down button — You will hear “Auto-hands-free
on” or “Auto-hands-free off”
NOTE: You must touch the Volume-down button within 2 seconds
after pressing the Power button, or you will turn the power off
and have to begin again. If the auto-hands-free feature does
not come on, you may need to reconfigure the S1 switch in the
base station. Call HME Customer Support at 1-800-848-4468
on” or “Auto-hands-free off”
NOTE: You must touch the Volume-down button within 2 seconds
after pressing the Power button, or you will turn the power off
and have to begin again. If the auto-hands-free feature does
not come on, you may need to reconfigure the S1 switch in the
base station. Call HME Customer Support at 1-800-848-4468
for assistance.
• The last auto-hands-free on/off message you hear will
remain in effect until you change it again or turn the
headset power off.
headset power off.
b. Configuration Settings
• With the power already on, press and hold the Power button
and press the B button. NOTE: You must press the B button
within 2 seconds after pressing the power button, or you
will turn the power off and have to begin again.
within 2 seconds after pressing the power button, or you
will turn the power off and have to begin again.
• You will hear “Configuration” in the headset.
• Select the desired configuration setting described
• Select the desired configuration setting described
below.
• When finished, press and release the B button to exit
the configuration-settings mode. You will hear “Power
on, lane (one or two)” in the headset.
on, lane (one or two)” in the headset.
• Configuration settings will remain in effect until you
change them again.
Hands-free On/Off Configuration
• Touch and release the Volume-down button — you will hear
• Touch and release the Volume-down button — you will hear
“Hands-free on.”
• Touch and release the Volume-down button again — you will hear
“Hands-free off.”
• You will continue to hear “Hands-free on” or “Hands-free
off ” messages alternating each time you touch and
release the Volume-down button.
When a car is at the speaker post (or menu board), touch and
hold the appropriate “A” button. If you can hear the sound of
the car or the customer with the “A” button held, you have
Hands-Free capability.
hold the appropriate “A” button. If you can hear the sound of
the car or the customer with the “A” button held, you have
Hands-Free capability.