Digital Monitoring Products Inc PC0086 Benutzerhandbuch

ACTIVATE ZONE 3

EXIT: 

  NO  YES

Select YES to enable the Request to Exit feature on zone 3. This zone provides the 

ability to cause a door strike to open the door.  No panel programming is required.  

4 DIGIT ENTRY

CARDS: 

  NO  YES

Select YES to enable the 4-Digit Entry Cards function on Home/Away or other systems 

that require 4-digit user codes.  Home/Away operation is available on the XRSuper6, 

XR20, XR40, and XR200 Command Processor™ panels.  

ALL?:  

  NO  YES

DELAY:  2

Select the number of seconds the keypad should wait when an area system displays  

ALL?  NO  YES during arming/disarming or a HOME/SLEEP/AWAY system waits during 

arming only.  If No or YES, or HOME,  SLEEP, or  AWAY is not pressed before the delay 

expires, the keypad automatically selects the YES or the AWAY key.  Select zero (0) to 

disable this feature.  The delay can be one to nine (1-9) seconds.  The delay also occurs 

when a Wiegand card is presented for arming the Home/Sleep/Away system.  After a 

card is presented, HOME  SLEEP  AWAY displays.  The keypad waits the programmed 

number of seconds before automatically sending AWAY to the panel. 

Accessing Keypad Diagnostics
If necessary, refer to Access the User Menu on the previous page.

KPD  KPD

OPT  DIAG 

  STOP

The Keypad Diagnostic option allows you to check the display segments, check the 

keyboard backlighting, and test individual keys.  
Press the Select key under KPD DIAG.  The keypad lights all display segments and 

illuminates the keyboard in green.  A few seconds later the keypad turns the display off 

and illuminates the keyboard in red.  The keypad then alternates between these two 

states for approximately two minutes.  Press COMMAND at any time to continue.  

PRESS KEY TO

TEST

The display changes to PRESS KEY TO TEST.  This option allows you to test each key on 

the keyboard to ensure it is operating properly.  Press and hold each key for about two 

seconds.  The key number being held appears in the display.  Verify the correct number 

displays before testing the next key. 

Z1  OPEN 

Z2  OPEN

Z3  OPEN 

Z4  OPEN

This option allows the keypads to display the current electrical status of the four 

protection zones.  The status is shown as OPEN, SHRT, or OKAY.  
Note: The Zone information displays on 7064 and 7060 keypads, but is not operational. 

INPUT WIEGAND

This option tests the reader input from DMP 1400 Series proximity credentials.  The 

display shows OKAY each time a good proximity read is received. 

Exiting the Installer Options
When done, press the CMD key once to return to the Installer Options screen.  Press the Select key under STOP to 

exit the Installer Options function.