Digital Monitoring Products Inc PC0193 Benutzerhandbuch

1

The 1136 is programmed in the panel as an output. Refer to the 

panel programming guide as needed. 
Note: For panels with Version 171 firmware or below, there must 

be a wireless keypad programmed into the system for the 1136 to 

function properly.

1.  In

 OUTPUT SETUP, enter the OUTPUT number. For the 

first 1136 added to a system, use the following output 

numbers: 

•  XT30/XT50 systems use output 34
•  XTLplus systems use output 54
•  XR150/XR550 systems use output 453

Additional 1136s can be programmed into any other 

available output slots.

2.  Enter the 

OUTPUT NAME.

3.  Enter the eight-digit 

SERIAL# and press CMD.

4.  Enter the 

SUPRVSN TIME (supervision time) and press 

CMD.

5.  Press

 CMD when TRIP WITH PANEL BELL displays.

6.  Press the back arrow when 

OUTPUT SETUP displays.

7.  Press 

CMD until STOP displays and then press any top 

row select key or area.

2

Since the 1136 does not have a visible survey LED, use a wireless 

device with a survey LED to confirm communication with the 

wireless receiver or panel. DMP recommends using an 1106 

Wireless Transmitter. This process ensures that the outlet you 

choose is in a good location.

1.  Open the wireless device and hold it over the standard 

110VAC wall outlet you would like to use.

2.  Press the tamper switch to send data to the wireless 

receiver and see if communication is confirmed or faulty.

Confirmed: If communication is confirmed, the LED 

blinks immediately on and immediately off for each 

press or release of the tamper switch.
Faulty: If communication is faulty, the survey LED 

remains on for about 8 seconds or flashes multiple 

times in quick succession.

3.  Relocate the device to a different outlet or relocate the 

wireless receiver until the survey LED confirms clear 

communication. 

The 1136 Wireless Remote Chime 

is a multi-function sounder that 

plugs directly into a standard 

110VAC wall outlet. 

The 1136 provides extra 

annunciation in installations that 

benefit from a louder keypad 

chime, or small multi-family 

applications where no keypad 

is installed and the system is 

controlled from an app.

The 1136 annunciates Chimes 

(Zone Monitor), as well as  

Entry Delay, Exit Delay and  

Alarm messages.

All DMP 1100 Series Wireless 

Receivers and burglary 

panels. See the last page for 

compatibility details.

Once you have located an outlet with confirmed communication 

to the panel, plug in the 1136. See Figure 1.

3