Lectrosonics Inc DB Benutzerhandbuch
DSW Digital Wireless System
Rio Rancho, NM
19
Copying Transmitter Settings To and From
the Receiver
the Receiver
Connect the key cable from the jack labeled KEY on
the front of the receiver to the micro USB port on the
side of the transmitter.
the front of the receiver to the micro USB port on the
side of the transmitter.
If transmitter settings are defined in the receiver, they
can be transferred to a connected transmitter, or cop-
ied from a transmitter to a receiver channel using the
key cable.
can be transferred to a connected transmitter, or cop-
ied from a transmitter to a receiver channel using the
key cable.
Transmitter Settings Screen
Press MENU/SEL and navigate to the TX MENU, then
to the SEND SETTINGS (microphone) icon. Press the
encoder to enter the transmitter settings screen.
to the SEND SETTINGS (microphone) icon. Press the
encoder to enter the transmitter settings screen.
Select the desired channel with the CHOOSE TX op-
tion at the bottom of the screen.
tion at the bottom of the screen.
Send Settings to Transmitter
After the channel is selected, highlight the SEND
SET option at the bottom of the screen. Connect the
transmitter with the USB cable and press the encoder
to start the transfer.
SET option at the bottom of the screen. Connect the
transmitter with the USB cable and press the encoder
to start the transfer.
The transmitter LCD will display RECEIVED when the
settings have successfully transferred.
settings have successfully transferred.
If the transfer cannot be completed, an error message
will appear.
will appear.
Get Settings from Transmitter
The settings in the transmitter can be transferred to the
receiver for storage or editing with the GET SET option
in the setup screen.
receiver for storage or editing with the GET SET option
in the setup screen.
The transmitter must be turned fully on and tuned to
the selected channel on the receiver.
the selected channel on the receiver.
Select the desired channel and then the GET SET
option. Turn the transmitter fully on with the RF output
enabled and press the encoder to start the transfer.
An error message will appear if no RF signal is being
received.
option. Turn the transmitter fully on with the RF output
enabled and press the encoder to start the transfer.
An error message will appear if no RF signal is being
received.
NOTE: Settings will be displayed on the Transmitter
Settings screen, but changes are not made here.
Settings are adjusted in the TX MENU as described
on previous pages, on the transmitter itself, or with
the Wireless Designer software.
Settings screen, but changes are not made here.
Settings are adjusted in the TX MENU as described
on previous pages, on the transmitter itself, or with
the Wireless Designer software.