3M Company LSD702 Benutzerhandbuch
10
Using the Handheld Device for the first time
Step 1 – Use 3M Data Management software
to export lists and 3M Handheld Software
onto a memory card.
1
Use the other software supplied with your system to
install and set up the Handheld Software (located
on the CD-ROM delivered with the handheld) on the
same computer where you installed the other
software.
install and set up the Handheld Software (located
on the CD-ROM delivered with the handheld) on the
same computer where you installed the other
software.
2
Export Handheld Software onto a memory card.
§ This occurs automatically whenever you export
§ This occurs automatically whenever you export
data to a memory card.
3
Insert the memory card into the handheld.
§ See
§ See
Inserting the memory card
on page 18.
Step 2 – Charge the battery and insert it into
the handheld.
1
See
Charging the battery
on page 17.
2
Insert the charged battery into the handheld.
Step 3 – Calibrate the screen
1
Press the Reset button
(located on the bottom of the handheld near the
antenna).
(located on the bottom of the handheld near the
antenna).
2
Follow the instructions to calibrate the screen using
the handheld stylus.
§ Tap Next at the Country/Date/Time screen.
the handheld stylus.
§ Tap Next at the Country/Date/Time screen.
§ Tap Done at the Setup Complete screen.
Step 4 – Load and set up the 3M software
1
Press and release the trigger on the handheld to load
software into RAM (takes approximately 15 seconds)
and display the Palm Preferences screen.
§ Continue to the next step without setting any
software into RAM (takes approximately 15 seconds)
and display the Palm Preferences screen.
§ Continue to the next step without setting any
preferences.
If the 3M software does not load properly, perform
the reset procedure on page 13 and try again.
the reset procedure on page 13 and try again.
2
Press and release the trigger on the handheld again
to display the 3M Software Home screen. (You may
have to set the time functions before the Home
screen appears.)
to display the 3M Software Home screen. (You may
have to set the time functions before the Home
screen appears.)
3
Refer to the 3M Handheld Software Manual for Staff
and Admin Setup procedures.
and Admin Setup procedures.
Insert a
memory card
memory card
Memory
Card
1
Memory
Card Drive
Memory
Card
702_003
Press and release
the trigger and wait
about 15 seconds for
the software to load.
the trigger and wait
about 15 seconds for
the software to load.
Pull the trigger again,
Home screen appears
Home screen appears
the
4
Trigger
Insert a charged battery
into the handheld reader
into the handheld reader
Charge the battery
2
Press the Reset button
Calibrate the display
3
Reset
Button
Stylus
702_026
Setup 2 of 4
In the following screen,
you
will be asked to tap the
will be asked to tap the
center of the target as
shown below. This ensures
Use the stylus to tap