3M Company LSD702 Benutzerhandbuch

Seite von 24
 
       
15
 
Adjusting the antenna  
 
If necessary, use the antenna adjustment tool 
provided to carefully adjust the swivel tightness of the 
handheld antenna. 
If the antenna is too loose 
§  Use the antenna adjustment tool to tighten (turn 
clockwise) the antenna adjustment screw slightly 
until the antenna swivels properly. 
§  Be careful to only turn the adjustment screw the 
minimum amount needed to adequately tighten the 
handheld antenna swivel.  
If the antenna is too tight 
§  Use the antenna adjustment tool to loosen (turn 
counterclockwise) the antenna adjustment screw 
slightly until the antenna swivels properly. 
 
  
 
702_011
Antenna
Adjustment
Screw
Antenna
Adjustment
Tool
 
Figure 8: Use the antenna adjustment tool to 
adjust the antenna. 
Cleaning the handheld  
The handheld may need occasional cleaning. 
§  Gently rub the handheld with a soft cloth dampened with a mild cleaning 
solution. Make sure that no liquids enter the handheld case. 
§  DO NOT spray cleaning solution directly on the handheld. 
 
Storing the handheld  
During storage, the handheld continues to use a small amount 
of battery power. Over time (approximately one week), the 
battery can lose its charge, requiring you to perform a reset.  
Storing the handheld for less than a week 
Install a fully charged battery in the handheld.  
§  To start using the handheld, press and release the trigger. 
Storing the handheld for more than a week 
Remove the battery from the handheld when storing it for 
more than a week. 
§  After storage, insert a fully charged battery and perform the 
Resetting the handheld
 procedure on page 13. 
 
 
 
 
IMPORTANT NOTE! 
Do not over tighten the antenna adjustment screw.  
Over tightening the antenna adjustment screw may 
damage the Handheld.