Checkpoint Systems Inc. FISOLRR Benutzerhandbuch
1-20
I L S O p e n P l u s 3 . 0 I n s t a l l a t i o n M a n u a l
possible (routed along the bottom of the board housing at the base of the gate). The cables
must never be allowed to contact the copper tube.
must never be allowed to contact the copper tube.
Setting the Multiplexer
By configuring the S1 DIP Switch settings as shown below, all multiplexer settings are
controlled by software. Jumpers are not required.
controlled by software. Jumpers are not required.
Figure 1.20
Multiplexer DIP-Switch and Jumper Positions
DIP Switch Configuration
The DIP switch should be configured as indicated in the following table:
Table 1.1
DIP Switch S1
1
2
3
4
5
6
7
8
ON
OFF
OFF
ON