Checkpoint Systems Inc. FISOLRR Manual De Usuario

1-20

I L S O p e n P l u s 3 . 0 I n s t a l l a t i o n M a n u a l

possible (routed along the bottom of the board housing at the base of the gate). The cables
must never be allowed to contact the copper tube.

Setting the Multiplexer

By configuring the S1 DIP Switch settings as shown below, all multiplexer settings are
controlled by software. Jumpers are not required.

Figure 1.20

Multiplexer DIP-Switch and Jumper Positions

DIP Switch Configuration

The DIP switch should be configured as indicated in the following table:

Table 1.1

DIP Switch S1

OFF