Tornado 9SYLTX2-1 Benutzerhandbuch
1N00-511 Genesis 80cm Boat Installation Manual - Export v1.0 08/03
©Tornado International Ltd. 2003
-5-
Confidential
Before Installation
All equipment (except UK) designed to operate off mains voltage supply (100v
to 240v) is supplied without a connecting plug. Ensure that the required
number of plugs are available before starting the installation.
Caution!
Check that the supply voltage matches the voltage setting on the front of the
PSU and Charger cases. (Dia. 5 & 6)
Tools & Items Required: (These are not supplied with the unit)
Small flat screwdriver
Medium flat screwdriver
Medium cross point screwdriver
Power drill
8mm drill bit
51mm hole cutter
10mm socket and ratchet
¼ whitworth socket (or adjustable spanner)
Soldering Iron
Staple Gun or 3mm cable clips
7mm cable clips
10off each coin/token used
Setting Out the Equipment:
1. Before starting the installation place the consoles on the floor in the
position they are to be mounted. The consoles may be mounted either
indoors or outside. Console number “1” should be on the left with the
consoles running in numerical order to the right.
indoors or outside. Console number “1” should be on the left with the
consoles running in numerical order to the right.
2. Place the Power Supply Unit (PSU) in the position it will be used. The rear
of the PSU has a large aluminium heat sink. It is important that the PSU is
positioned so that there is an uninterrupted flow of cool air over the heat
sink.
positioned so that there is an uninterrupted flow of cool air over the heat
sink.
Caution!
The PSU must be mounted indoors and in such a position that the public
do not have access to it. It must be protected from water.
The PSU must be mounted indoors and in such a position that the public
do not have access to it. It must be protected from water.
3. Place the chargers in the position they will be used. The top and bottom of
the charger case has vents to provide cooling. It is important that the
chargers are positioned so that there is an uninterrupted flow of cool air
over the vents. Caution!
chargers are positioned so that there is an uninterrupted flow of cool air
over the vents. Caution!
The chargers must be mounted indoors and in such a position that the
public do not have access to them. They must be protected from water.
public do not have access to them. They must be protected from water.
4. Check that the PSU and charger mains cables will reach the electric
supply sockets.
5. Lay out the 24V PSU cable and check that it is long enough to reach from
the master console to the PSU.